Everbuild STICK2® All-Purpose Clear Adhesive is a strong, clear, quick drying adhesive suitable for a variety of household repairs and hobby uses. Will stick ceramics, porcelain, pottery, wood, card, paper, most plastics, leather, cork, linoleum, rubber, stone, glass, metals and dense fabrics to both themselves and each other.
Always open and use this product over a protected work surface.
Surfaces to be bonded must be clean, dry and free from dust. Use only in well ventilated areas. Do not breathe vapour.
POROUS SURFACES (fabrics, ceramics etc.) Unscrew cap and spread a thin even layer of adhesive onto one surface. Press two surfaces together firmly.
NON-POROUS SURFACES (plastics, metals etc.) Improve adhesion by abrading both surfaces with sandpaper. Unscrew cap and spread a thin even layer of adhesive onto both surfaces. Allow adhesive to dry to a tough tacky finish (about 5-10 mins) then press both surfaces together firmly.
In both cases, full strength is obtained after 24 hours at 20°C
Replace cap immediately after use to keep adhesive usable.
COSHH Datasheet: Download 1146
H319 Causes serious eye irritation.
H336 May cause drowsiness or dizziness.
P280 Wear protective gloves/protective clothing/eye protection/face protection/hearing protection/…
P304 + P340 IF INHALED: Remove person to fresh air and keep comfortable for breathing.
P312 Call a POISON CENTER/doctor/…/if you feel unwell.
P370 + P378 In case of fire: Use… to extinguish.
P305 + P351 + P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing
GHS02 Flammable
GHS07 Health hazard/Hazardous to the ozone layer